Download Print this page

Whirlpool GH9115XEB0 Installation Instructions Manual

Microwave hood combination

Advertisement

Quick Links

IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer:
Leave Installation
Instructions
with homeowner.
Homeowner:
Keep Installation
Instructions
forfuturereference.
Save Installation
Instructions forelectrical
inspector's use.
Part No. 3828WSUO002/4359330
Microwave Oven Hood
Combination
_olq_

Advertisement

loading

Summary of Contents for Whirlpool GH9115XEB0

  • Page 1 IMPORTANT: Part No. 3828WSUO002/4359330 Read and save these instructions. Microwave Oven Hood Combination IMPORTANT: Installer: Leave Installation Instructions with homeowner. Homeowner: Keep Installation Instructions forfuturereference. Save Installation Instructions forelectrical inspector's use. _olq_...
  • Page 2: Parts Supplied For Installation

    Before you start... Important: Observe all Proper installation is the installer's responsibility. A qualified technician should governing codes and Excessive Microwave Energy Exposure install this microwave oven hood. Make ordinances. Do Not attempt to operate this microwave sure you have everything necessary oven with the door open.
  • Page 3: Venting Requirements

    Venting roof requirements requirements Ductwork needed for Installation is not included. Wall and roof caps used must have back-draft damper. diameter _ I o°""""[-..un00u , ' " "_ wall elbow "** =.o,: 3-I/4" 3-I/4" x I0" to round round duct ductwork transition...
  • Page 4: Venting Preparation

    Venting preparation blower u0lt exhaustports Usesidecutters or tin snips. blower unit mounting screws blower blower plate knockouts "A" Electrical Shock Hazard Use side cutters or tin snips to cut and Do not pull or stretch blower wiring. blower plate remove knockouts marked "A _ from...
  • Page 5 nli, 18. 19. 20. 21.22. 23. 24. 26. • 8.11. 4. 6. 7. 10. 12. 14. 15. Numbers correspond to steps. • °I° [] Determine which venting method (roof-venting, wall-venting, or ventless) you need to use. This microwave oven hood is manufactured for ventless (recircuiating) installation.
  • Page 6 J Roof venting: Do Not install Slide • Remove locking pin and washer. ductwork at this time. Go to Step 14. washer onto lock If wall-venting or ventless installation is used, pin and set inside go to Step 24. upper cabinet, Wall venting: Install ductwork through...
  • Page 7 If microwave oven Accessory kits does not operate... Accessory kit no. 4378403 - Almond 4158439 - White • Check that the circuit breaker is not 4158311 - Black tripped or the house fuse blown. Filler panel kits are available from your °...

This manual is also suitable for:

Gh9115xeq0Gh9115xeq1Gh9115xeb1Gh9115xeb2