Advertisement
U
ii
nli,
1.
18. 19. 20. 21.22.
23. 24. 26.
•
8.11.
17.
4. 6. 7. 10. 12. 14. 15.
Numbers
correspond
to steps.
•
25.
25.
o
°I°
o
[] Measure
the bottom
of the upper
cabinet
frame. Trim the edges
"A',
"B" and
"C" on the upper cabinet
template
so that
the template
will fit on the bottom
of the
upper cabinet,
if upper cabinet
has a
recessed
frame, trim template
so that it fits
inside the recessed
area. Align the
centerline
of the upper cabinet
template
with the centerline
of the wall template;
then securely
tape
or tack the upper
cabinet
template
in place,
Electrical Shock Hazard
Take special care when drilling holes into
the wall.
Electrical wires may be concealed behind
the wall covering, and contact with them
could result in death or serious injury.
,, Find the points on the wall template
labeled
"D", "E', "F', and "G". Drill a 3/16""
diameter
hole at the points that are over a
wall stud and a 3/4" diameter
hole at the
points that are over drywall.
[]i
___,_____1
e_. _ _L
_ _'"'_ _ _ _
F
[] Locate the wall stud closest to the
center of the areas marked
"H" and "1" on
the wall template.
Drill 3/16"' holes into the
wall stud in each
of the areas, if a wall stud
isnot located
within these areas, drill 3/4"
diameter
holes nearest to the center of the
areas as possible,
If there is not a wall stud within the areas
marked
"H" and "l" and not behind
points
marked
"D","E ", "F" and "G', DO NOT
install microwave
oven hood. (Consult
building
inspector.)
Electrical Shock Hazard
Install power supply cord bushing around
hole drilled in metal cabinet.
Failure to do so could result in death or
serious injury.
[] Cut out or drill a 2" diameter
hole at
the area marked
"M °, "power
supply cord
hole" on the upper cabinet
template.
If
upper cabinet
is metal, install power supply
cord bushing around
the edge
of hole to
prevent
damage
to the cord from the
rough metal edge,
[] Determine
which venting
method
(roof-venting,
wall-venting,
or ventless) you
need to use. This microwave
oven hood is
manufactured
for ventless (recircuiating)
installation.
Make adjustments
to
microwave
oven hood if wall- or roof-
venting
installation
is needed.
See "Venting
preparation,"
Panel C.
0
[] For ventless installations, go to
Step 14,
To vent through the roof, cut out the
rectangular
area marked
"L" on the upper
cabinet
template,
To vent through the wall, cut out the
rectangular
area marked
"O" on the wall
template.
n
[]
Drill a 3/8" hole at points "J", "K',
.I
and "N" on the upper cabinet
template.
Remove the upper-cabinet
and wall
templates.
filler block
upper cabinet
bottom
masking tape
If boffom of upper cabinet
is recessed,
2" x 2" filler blocks (not included) the same
recess thickness
as the upper cabinet
will
be needed.
Mark the center of each
filler
block and drill a 3/8" diameter
hole at the
marks. Align filler blocks over the two holes
"J" and "K" in the cabinet
bottom
and
attach
to cabinet
bottom
with masking
tape.
Panel D
Advertisement
