Installation: Forward-Facing
Forward-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates the forward-facing lap-
shoulder vehicle belt route.
• When not in use, always store the LATCH
connectors in storage pouches sewn in
cover above rear-facing lock-offs.
1 Place the child restraint forward-facing
on the vehicle seat .
• Restraint must be in the full upright
position when installed in forward-facing
mode with children over 33 pounds (15kg).
• Installation can be improved by the use of
the Versa-Tether
2 Pull the vehicle belt out, then pass it over
the LATCH bar, through the forward-facing
belt slots, then over the LATCH bar on the
other side (Fig. B) .
3 Verify that the vehicle belt is not
twisted, then buckle (Fig. C) .
18
®
(see pages 23–25).
A
B
C