Britax Marathon User Manual page 13

8 Push the child restraint firmly into the
vehicle seat while pulling each LATCH
harness tight (Fig. D) .
9 Verify that all connections are secure
and the restraint is stable .
NOTE:
• The back angle of the child restraint
should not exceed 45º when properly
installed in the rear-facing position .
• Installation can be improved by the
use of the Versa-Tether
can be adjusted by tightening the tether as described on page
24, using anchor point 3 .
• If there is a problem stabilizing the child restraint, place a rolled
towel in the crease of the vehicle seat to help level the child
restraint base .
WARNING: DO NOT raise the base beyond horizontal or off of the
vehicle seat; doing so will reduce the protection for the child .
Removal
• Release each LATCH harness from the LATCH anchor by
pressing the red release button on the LATCH connector .
• If connected, disconnect the Versa-Tether
anchor .
• When not in use, always store the LATCH connectors in
storage pouches sewn in cover above rear-facing lock-offs .
Installation: Rear-Facing
(see pages 23–25) . The recline angle
®
D
from the tether
®
11