Style 2: Direct wire strain relief
•
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
/ .............
Position cord/conduit
plate as shown in the following
illustration.
•
Replace cord/conduit
plate and insert screws.
•
Assemble a UL listed conduit connector in the opening.
Feed the flexible conduit through the conduit connector
allowing enough slack to easily attach wiring to the
terminal block.
•
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has:
And you will be
Go to Section:
connecting to:
4-wire receptacle
A UL listed,
4-wire connection:
(NEMA type 14-50R)
250-volt
Power supply cord
minimum,
40-amp, range
power supply
cord
4-wire direct
A fused
4-wire connection:
disconnect
or
Direct wire
circuit breaker
box
(12.7
cm)
3-wire receptacle
A UL listed,
(NEMA type 10-50R)
250-volt
minimum,
40-amp, range
power supply
cord
3-wire connection:
Power supply cord
3-wire direct
A fused
3-wire connection:
1-
disconnect
or
Direct wire
circuit breaker
box
A. Removable
retaining nut
B. Strain relief