Advertisement
Bare Wire Torque Specifications
Attaching terminal lugs to the terminal block - 20 Ibs-in. (2.3 N-m)
Wire Awg
Torque
8 gauge copper
25 Ibs-in. (2.8 N-m)
6 gauge aluminum
35 Ibs-in. (4.0 N-m)
3. Use 3/8"nut driver to connect the bare (green) ground wire to
the center terminal block post with one of the 10-32 hex nuts.
A
B
F
E
D
C
A. 10-32 hex nut
B. Line 1 (black)
C. Ground-link
screw
D. Bare (green) ground wire
E. Line 2 (red)
F. Terminal lug
4. Connect line 1 (black) and line 2 (red) wires to the outer
terminal block posts with 10-32 hex nuts.
5. Securely tighten hex nuts.
6. Replace terminal block access cover.
1.
2.
Making sure the anti-tip bracket is installed:
•
Look for the anti-tip bracket securely attached to floor or
wall.
•
Slide range back so rear range foot is engaged with
anti-tip bracket.
If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements"
section.
Place rack in oven. Place level on rack and check levelness of
range, first side to side; then front to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
Use wrench to adjust leveling legs up or down until range is level.
Push range back into position. Check that rear leveling leg is
engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory
baking conditions.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See "Level Range."
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by protective shipping
material. Dry thoroughly with a soft cloth. For more
information, read the "Range Care" section of the Use and
Care Guide.
6. Read "Range Use" in the range Use and Care Guide.
7. Plug power cord into appropriate
outlet. Slide range into its
final location. Check that the flexible conduit or power supply
cord are not bent.
8. Replace storage drawer.
9. Turn power on. Turn on surface burners and oven. See the
Use and Care Guide for specific instruction on range
operation.
If range does not operate, check the following:
•
Household fuse is intact and tight; or circuit breaker has not
tripped.
•
Range is plugged into an outlet.
•
Electrical supply is connected.
•
See "Troubleshooting"
in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.
11
Advertisement
