Table of Contents
Advertisement
transmission
2) Wireless sensor used
short
3) Haven't pull out
4) Electromagnetic
5) The wireless receiver
False Alarm
1) PIR Motion sensor
2) Used 24H zones or
3) NC/NO/EOL is
Alarm without
1) GSM Operator
SMS/
Alarm without
Dial/
2) Haven't setup SMS
No action
after send
SMS
3) Caps Lock letters in
command
Any questions please help to contact us feel free.
A Top Safety and Protection Solution In The Worldwide!
PT2262 IC, and
incorrect Value;
wireless antenna;
interference;
in the panel with
problem.
installation incorrect;
SOS Zones or
Watchdog zone.
incorrect.
communication
protocol;
Alert/Auto dial
Numbers.
the SMS Commands.
The End!
Page
2) Please correct the resistor value to 3.3M
Ohm of the PT2262 Wireless sensor;
3) Please pull out the wireless sensor
antenna;
4) Please install the wireless sensors or
alarm panel away the electric
equipments;
5) Please contact your distributors or
manufacturer to replace it.
1) Please see the PIR Motion sensor
installation user manual carefully;
2) Please check if any sensor assigned to
these special zones and made incorrect
activated;
3) Please check the detector NC/NO type
and NC/NO/EOL Correctly, and you're
sure connect a 2.2K Resistor in series in
the un-use input ports.
1) Please setup the SMS Alert Numbers;
2) Please help to see Page 15, the sample
of setup the telephone numbers;
3) Please check the commands with CAPS
LOCK and correct format.
4) Also, please help to change another
GSM Operator SIMCard to test it.
of 32 Ver 1.10
Advertisement
Table of Contents
