4.
Remove the battery (see
5.
Remove the following components:
a.
Keyboard (see
b.
Fan (see
Fan on page
c.
Heat sink (see
Remove the graphics card:
1.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the graphics card to the computer. (The
edge of the board opposite the graphics card slot rises away from the computer.)
2.
Remove the graphics card (2) by sliding it away from the graphics card slot at an angle.
NOTE:
The graphics card is designed with a notch (3) to prevent incorrect installation.
Reverse this procedure to install the graphics card.
Battery on page
47).
Keyboard on page
58)
63)
Heat sink on page
64)
Component replacement procedures
69