Advertisement
How to Install
NOTE: Top Rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of (5/16").
This is necessary for proper condensed water utilization
and drainage. If you are not using the Side Panels for
any reason, this pitch to tile rear must be maintained!
Place unit on flooL\ a bench or a table. There is a
Left and Right Window
Filler Panel - be sure to
use the proper panel for each side.When
installed
the flange for securing
the panel in place to the window
sill
will be facing into tile room.
A. Hold the
Accordion
Panel m one
hand and
gently
pull
back the
center to free
tile open end.
See Figure 2.
C.
Once tile panel
has been
installed
on tile
side of tile
cabinet,
make
sure it sits
securely
inside
the frame
channel by
making slight
adjustments.
Slide the top and bottom ends of the frame
into the top and bottom rails of tile cabinet.
Figure 5.
D. Slide the panel all tile way in and repeat on the other
side.
NOTE:
If storm window
blocks AC, see FIG. 14.
Keep a filial grip on the air conditioner,
carefully
place the unit into the windo_
opening
so the
bottom of the air conditiouer
frame is against the
window
sill (FIG. 6 & FIG. 6A). Carefnlly
close the
window behind the top rail of the unit.
B. Slide the fl'ee end ('T'section/of
the panel into tile
cabinet
as shown in Figures 3A, 3B & 4. Slide the
panel down. Be sure to leave enough
space to slip the
top and bottom of the frame into the rails on the cabinet.
WINDOW SILL
Extend the side panels out a_ainst the window
frame (FIG. 7).
Advertisement
