Table of Contents
Advertisement
Note: The driver and front passenger Belt-Minder® are deactivated and
activated independently. When deactivating or activating one seating
position, do not buckle the other position as this will terminate the
process.
Note: If you are using MyKey®, the Belt-Minder® cannot be disabled.
Also, if the Belt-Minder® has been previously disabled, it will be
re-enabled during the use of MyKey®. See the MyKey® chapter.
Read Steps 1 - 4 thoroughly before proceeding with the programming
procedure.
The driver and front passenger Belt-Minder® features can be deactivated
or activated by performing the following procedure:
Before following the procedure, make sure that:
• the parking brake is set
• the transmission selector lever is in position P (automatic
transmission) or N (manual transmission)
• the ignition is on
• the driver and front passenger safety belts are unbuckled.
1. Turn the ignition on. DO NOT START THE ENGINE.
2. Wait until the safety belt warning light turns off (about one minute).
• Step 3 must be completed within 30 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, buckle then unbuckle the
safety belt three times at a moderate speed, ending in the unbuckled
state. Step 3 must be completed within 30 seconds after the safety belt
warning light turns off.
• After Step 3, the restraint system warning light (airbag light) will be
turned on for three seconds.
4. Within about seven seconds of the light turning off, buckle then
unbuckle the safety belt.
• This will disable the Belt-Minder® feature for that seating position if it
is currently enabled.
• This will enable the Belt-Minder® feature for that seating position if it
is currently disabled.
2014 05+ Mustang (197)
Owners Guide gf, 1st Printing, November 2012
USA (fus)
Safety Belts
41
Advertisement
Table of Contents
