Dry Operation; Timer Operation - Zibro S30xx Operation Manual

NOTE!
• In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN, HEAT and
DRY by sensing the difference between the actual ambient room temperature and the set
temperature on the remote controller.
• If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
COOL, HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY,
HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button
2. Push the + or - button (
most comfortable settings are 21ºC or above.
3. Push the Fan button
4. Push the On/off button
settings. Push the On/off button
NOTE!
The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and
4 are applicable.

DRY Operation

1. Push the Mode button
2. Push the + or - button (
3. Push the On/off button
mode. Push the On/off button
NOTE!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the
air conditioner when in DRY mode will automatically operate many times without running the
COOL and FAN mode.

TIMER Operation

Push Timer on/off button (
set by the remote controller for the timer function is limited to a period of between 0.5 and less than 24
hours.
1. To set the STARTING time.
1.1 Push the Timer on button
the starting operation and the signal "h" will be shown on the Timer display area. You are now ready
to reset the time to START the operation.
1.2 Push the Timer on button
1.3 After setting the Timer on ,there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
2. To set the STOPPING time.
2.1 Push the Timer off button
time for the timer off operation in hours will be shown on the Timer display area. You are now ready
to reset the time of the STOP operation.
2.2 Push the Timer off button
2.3 After setting the Timer off, there will be half a second delay before the remote controller transmits
the signal to the air conditioner.
and ) to set the desired room temperature. When in COOLING mode, the
to select the FAN mode of AUTO, HIGH, MED or LOW.
. The operation lamp lights and the air conditioner starts to operate per your
again to stop this unit operation.
to select DRY.
and ) to set the desired temperature.
. The operation lamp lights and the air conditioner starts to operate in the DRY
again to stop this unit operation.
and ) to set the on and off times of the unit. The effective operation time
, then the remote controller display shows ON TIMER, the last set time for
again to set desired unit start time.
and the remote controller display will show OFF TIMER and the last set
again to set the time you want to stop the operation.
.
4
121