Do you have a question about the DX 203 and is the answer not in the manual?
Questions and answers
Sandra Carbery
March 3, 2025
I would like to replace the control panel as the handle has broken. The model is DX 203 it has been in place since approximately 2005. The panel measures 590 x 120 x 40. Do you know if the part is still available and is it difficult to replace.
2 comments:
Mr. Anderson
March 3, 2025
The context indicates that the control panel for the Dishlex dishwasher, including the DX 203, can be purchased online. The replacement process is described as simple, taking about 10 minutes. It involves unscrewing six Phillips screws, disconnecting the control panel with its wires, and installing the new panel. The task is considered easy and can be done without professional help.
This answer is automatically generated
Sandra Carbery
March 4, 2025
@Mr. Anderson. Thank you very much for your response, Mr. Anderson. I will check online for the replacement part.
Ron Collins
March 2, 2025
how do you clean water spinners
1 comments:
Mr. Anderson
March 2, 2025
If the holes in the spray arms (water spinners) become clogged, remove any remaining debris using a cocktail stick.
This answer is automatically generated
Peter Hopkins
July 5, 2025
The power button is on, but no lights illuminate and even though I turned it off and on at the PowerPoint, still doesn’t illuminate at all.
It’s a Dishlex DX203
Jenny Deppeler
June 16, 2025
The handle on my Dishlex 203 dishwasher is broken can it be replaced or do I have to buy the whole panel.
Amy Irving
May 30, 2025
Could you help me understand why my dishwasher my dyslexdishwasher keeps stopping at the 20 minute mark please
• A qualified and competent person must do the Contact your local Customer Care Centre. plumbing installation. • Do not drill into the sides of the appliance otherwise • Do not change the specifications or modify this prod- damage to hydraulic and electrical components may uct.
Follow these steps to set the Button Lock function: To do this you must cancel the set program. Refer to 'Select and start a washing program'. 1. Switch on the appliance. 2. Set a washing program. Delay start button 3. Start the washing program. Use the delay start button to delay the start of the 4.
Caution! Do not fill the rinse aid dispenser with Wash hands to remove any residue of rinse aid other products (e.g. dishwasher cleaning agent, from skin. liquid detergent). There can cause damage to the appliance. Adjusting the rinse aid dosage The rinse aid is set at the factory at position 3.
Maximum height of the dishes in : upper basket lower basket Lower position 24 cm 27 cm Arrange the items to let For longer items, fold the water touch all surfaces. cup racks up. Prevent to put plates in the first three sectors in the front part of the basket.
best cleaning results during short washing programs. Use long washing programs when you use detergent tablets to fully remove the detergent. Use of combi detergent tablets These products are detergents with a combined clean- ing and rinsing functions. They can contain also other cleaning agents.
Fill the detergent dispenser with detergent before you – When you cancel delay start, you also cancel set a new washing program. the washing program. 2. Set a new washing program. Select and start a washing program with delay start End of the washing program 1.
tergents. Do not use abrasive products, scouring pads or solvents (acetone etc.). Internal cleaning Do an inspection at intervals of 3 months. Set a washing program for heavily soiled dishes. Use detergent, but do not put dishes in the appliance. Long periods of non-operation Do these steps when you do not use the appliance for a long period:...
Fault code and malfunction Possible cause and solution • The running program light continues • The water tap is blocked or restricted with limescale. to flash Clean the water tap. • The 'Finished' indicator light flashes • The water tap is closed. once Open the water tap.
The cleaning results are not satisfactory There are streaks, milky spots or • Decrease the rinse aid dosage. a bluish coating on glasses and dishes Dry water drop stains on glasses • Increase rinse aid dosage. and dishes • The detergent can be the cause. Technical data Dimensions Width (mm)
Installation Fitting under a counter Adjusting the level of the appliance Make sure that the appliance is level to close and seal Warning! Make sure that mains plug is the door correctly. If the level of the appliance is correct, disconnected from the mains socket during the door does not catch on the sides of the cabinet.
The water pressure must be in the limits (refer to 'Tech- The appliance has a security feature to prevent dirty nical data'). Make sure that the local water authority water going back into the appliance. If, the spigot of the gives you the average mains pressure in your area.
Page 15
Always plug the mains plug onto a correctly installed Never unplug the appliance by pulling on the cable. approved socket. Always pull the plug. Do not use multi-ways plugs, connectors and extension Test the appliance. Run a quick washing program and cables.
Warranty conditions, repair or replace any parts which it considers to be defective. You agree that any re- placed Appliances or parts become the property FOR SALES IN AUSTRALIA AND NEW ZEALAND of Electrolux. This warranty does not apply to light This document sets out the terms and conditions globes, batteries, filters or similar perishable of product warranties for Electrolux branded ap-...
Page 17
governed by the law applicable in the Australian – in the case of Appliances, at its option, to the State where the Appliance was purchased or the replacement or repair of the Appliances or the law applicable in New Zealand if the Appliance supply of equivalent products or the payment was purchased in New Zealand.
Need help?
Do you have a question about the DX 203 and is the answer not in the manual?
Questions and answers
I would like to replace the control panel as the handle has broken. The model is DX 203 it has been in place since approximately 2005. The panel measures 590 x 120 x 40. Do you know if the part is still available and is it difficult to replace.
The context indicates that the control panel for the Dishlex dishwasher, including the DX 203, can be purchased online. The replacement process is described as simple, taking about 10 minutes. It involves unscrewing six Phillips screws, disconnecting the control panel with its wires, and installing the new panel. The task is considered easy and can be done without professional help.
This answer is automatically generated
@Mr. Anderson. Thank you very much for your response, Mr. Anderson. I will check online for the replacement part.
how do you clean water spinners
If the holes in the spray arms (water spinners) become clogged, remove any remaining debris using a cocktail stick.
This answer is automatically generated
The power button is on, but no lights illuminate and even though I turned it off and on at the PowerPoint, still doesn’t illuminate at all. It’s a Dishlex DX203
The handle on my Dishlex 203 dishwasher is broken can it be replaced or do I have to buy the whole panel.
Could you help me understand why my dishwasher my dyslexdishwasher keeps stopping at the 20 minute mark please