High-Speed Needle - Team Losi Losi Mega Baja Operation Manual

Base Start-up Settings from the Factory
High-Speed Needle—3
Low-Speed Needle—2
1
Engine Tuning
After the engine is broken in, you can tune it for optimum performance. When
tuning, it is critical that you be cautious of overheating as severe damage and
premature wear can occur. You want to make all carburetor adjustments in
"one hour" increments.
Low Speed Adjustment
The low speed adjustment affects the idle and slightly off idle performance.
The optimum setting allows the motor to idle for at least 8−10 seconds. The model
should then accelerate with a slight amount of sluggishness and a noticeable
amount of smoke. The simplest way to check this is to make sure the engine has
been warmed up and let the engine idle for 8−10 seconds. If the low speed mix-
ture is so far off that the engine won't stay running this long, turn the idle stop
screw clockwise, increasing the idle speed. With the engine at idle, pinch and hold
the fuel line near the carburetor, cutting off the flow of fuel, and listen closely to
the engine rpm (speed). If the low speed needle is set correctly, the engine speed will increase only slightly and then die.
If the engine increases several hundred rpm before stopping, the low speed needle is too rich. Lean the mixture by turning
the needle clockwise one hour and trying again. If the engine speed does not increase but simply dies, the needle is too
lean and needs to be richened up by turning the needle counterclockwise one hour before trying again. After you have
optimized the low speed setting, the engine will probably be idling faster. You will have to adjust the idle stop screw
counterclockwise to slow down the engine idle speed. The engine should accelerate at a constant pace without
hesitating.

High-Speed Needle

As you turn this clockwise (leaner),
less fuel enters the engine.
Turning it counterclockwise
(richer) allows more fuel to enter
the engine.
/ turns out from bottom
1
2
/ turns out from bottom
2
Faster
Slower
Idle Speed
Screw
Leaner
Richer
High-Speed
Needle
Idle Speed Screw
As you turn this clockwise, it
increases the carburetor opening
at idle and increases idle speed.
Turning it counterclockwise
decreases the opening and idle
speed.
Carb Opening
Page 
Carb Adjustments:
Make all carburetor adjustments
in one-hour increments.
Imagine the slot in the needle is
the hour hand on a clock. Adjust
it as though you were moving
the hour hand from one hour to
the next or previous one.
Richer
Leaner
Low-Speed
Needle
Low-Speed Needle
As you turn this clockwise (leaner),
less fuel enters the engine.
Turning it counterclockwise
(richer) allows more fuel to enter
the engine.