Changing Snap-On Presser Feet; Changing Screw-On Presser Feet - Singer 6201; 6211 User Manual

CHANGING SNAP-ON PRESSER FEET (B),(D),(J)
Your machine comes with the General Purpose Presser Foot (B) already at-
tached, You can easily change to any one of the other presser feet which snap onto a
common shank by following the directions below.
1. Raise needle to its highest position
2 by turning hand wheel toward you.
. Raise presser foot using presser foot
lifter at back of machine.
. Push toe of presser foot (1) up, until it
N>
-,snaps
off the shank (2).
. Remove foot from machine
* Place new foot under center of
3
shank.
. Lower presser foot lifter, fitting shank
over presser foot pin (3).
.Don't turn screw. Instead, push
presser foot screw (4) down, firmly
4
CHANGING SCREW-ON PRESSER FEET (H),(G)
Some special presser feet can be purchased at your sewing center with built-in
shanks that can be replaced as follows:
. Raise needle and presser foot.
0 * Loosen presser foot screw (1) and
2 7
remove presser foot with shank (2),
1 guiding it toward you and to the right.
. To replace presser foot with shank,
/
hook shank around the presser bar
and tighten presser toot screw with
bIB (t h e
use of acoin,
7