Changing a
snap-on presser
foot
TURN OFF THE MACHINE BEFORE CHANGING A
PRESSER FOOT.
Your machine is assembled with a general purpose
presser foot. You may easily replace it with other
presser feet, which are inserted in the same shank by
following the instructions:
1. Turn hand wheel toward you until the needle is in its
highest position and lift presser foot.
2. Lift lever "A" slightly up. The presser foot will snap off
the shank (illustration 1).
3. Place the new presser foot with its pin under the
center of shank fitting. Lower presser foot and it will
be firmly connected (illustration 2).