Haier HWM50TLF Use And Care Manual page 19

Installing Your W asher:
Read though these Instructions Carefully beforeinstallation.
1. Insert a new flat washer into eachendof the water inlet hoses.
Fir mly put the washers in the coupling.
2. Connect t he hot and coldwater inlet hosesto the hot and
coldwater Faucet.
3. Connect the other end to the corresponding washer inlet located at the back of
machine.
Note: You mayhaveto use pliers to tightenthe coupling. Do not over tighten
because you maycausedamage to the valve.
You should use the new hose-sets supplied with the washer. Old hose-sets
should not be reused.
4.install the drain hose to the side of the washer using the drain hose damp provided.
The drain hose must be placed into a drainpipe or sink at least 1 1/2inches in diameter.
Use the gooseneck to the hose in place. To avoid possible water back up, the drain
hose must reach a minimum height of 900mm and a maximum height of 1200mm.
Water Inlet
5.Pug in the washer to a regular 230-240Volt/50Hz,10Amps outlet.
Note :Carefully inspect all around the machine and at the back for
any leaks, and tighten any loose connections.
Caution: If, after completing thesesteps,you are unsure that unit is properly
installed, contact a qualified installer. To ensurethat your W asher is
properly installed it is recommended t hat it be installed by a cer t ified
installer.
Water Supply Hose
Goose Neck
Hose Bend
Drain Hose
18