Unpacking Your Washer; Levelling Your Washer; Steps For Installation - Haier HWM50TLF Use And Care Manual

Unpacking Your W asher
Removeall packingmaterials.This includesthe foambaseand all
adhesivetapeholding the washer accessories inside and outside.
Open the top lid to removethe styrofoamdrum brace.Pull to remove.
Note: Save drum brace.Reinstall when movingthe washer .
Inspectand removeany remainsof packing,tapeor printed
materialsbeforeusing the washer .
Leveling Your W asher
Your washer has 4 levelinglegs; which
are locatedon the four bottom
corners. After properly placingyour washer in its final position, you can
level your washer .
Levelinglegs canbe adjustedby turning themcounterclockwise to raise
your washer or turning themclockwiseto lower your washer .

Steps for Installation

Selecta suitablelocationfor the washer on a hard evensurfaceaway from direct
sunlight or heatsourcee.g. radiators, baseboardheaters,cookingappliancesetc.
Any floor unevenness should be corrected with the levelinglegs locatedon the
bottomcorners of the washer . The washer mustbe placedat room temperature.
You mustnot placewasher where the temperature is at below freezing.
Installing the Bottom Panel:
The purpose of the bottom panel installation is to block the
noise and give you quiet performance of the washer during
the operation.
Steps:
1.You must first lay the washer on its back.
2.Locate the panel on to the bottom of the machine.
3.Use a screwdriver to tighten the screws securing the panel to
bottom of the washer.(8 screws are supplied)
4.Once all screws are tight and the panel is secure return the washer to
its standing position.
High
Low
17
Adjustable foot