Advertisement
Available languages
Available languages
Important
Notes to the Installer
1.
Read all instructions contained
in these installation
instructions before installing appliance.
2.
Remove all packing material from appliance before
connecting the electrical supply.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note
to the Consumer
Keep these instructions for future reference.
IMPORTANT
SAFETY
INSTRUCTIONS
• Be sure your appliance
is installed
and plugged
into a 120 Volt grounded outlet.
• This appliance
must be electrically
grounded
in
accordance with the National Electrical Code ANSI/
NFPA No. 70--latest
edition
in the United States,
or CSA C22.1, Part
1 in Canada,
and local code
requirements.
Tools You Will Need
Phillips® Screwdriver
Pencil
Ruler or Tape Measure and Straight-edge
Hand Saw or Saber Saw
Spirit Level
Warm & Serve Drawer
Installation
1.Locate the 2 anti-tip brackets supplied as shown on fig. 1.
t_25
stlG"
/
.-'/24"
(64.3 cm) Max.
(60 cm) Min.
/
(732.15cm) -/
_
Figure 1
2.Slide drawer into cutout opening until front frame of
drawer is flush against cabinet. Be careful not to pinch
electrical cord.
3.Remove the drawer as instructed
in the Use & Care
Guide and secure drawer housing to cabinet using the
3 nickel-plated
screws supplied (see Figure 2). Do not
overtighten
screws.
4.The 60" (1 52 cm) appliance power cord can now be
connected into tile 120 Volt outlet.
5.Proceed with mounting built-in oven above the drawer
(if applicable). Follow installation instructions
provided
with built-in oven. Make sure to use anti-tip brackets
supplied with the built-in oven.
Use screws
supplied to attach
drawer to front of
cabinet.
Figure 2
Model
and
Serial
Number
Location
The serial plate is located as shown below.
When ordering parts for or making inquiries about your
Warm & Serve Drawer, always be sure to include the
model and serial numbers and a lot number or letter from
the serial plate on your Warm & Serve Drawer.
Serial Plate Location
Combination
Warm & Serve Drawer
and Cooktop
Installation
A
Minimum Depth Spacing To Clear Cooktop Burner Box
Electric Cooktop
Spacing
"A"
Gas Cooktop
E301C75, E361C75
4.5" (11.43cm)
E30EC65, E36EC65
6.0" (15.24cm)
E36EC75
7.5" (19.05cm)
8.5" (21.59cm)
E36GC75
E30EC70, E36EC70
5.0" (12.7cm)
Advertisement
