Electrolux EIFLS60LSS0 Installation Manual page 9

installation instructions
Leveling your washer
Excessive noise and vibration can be prevented by
properly leveling the washer.
1.
,
.
For free standing installation and with the
washer within 4 feet (1 m) of its final location,
place a level on top of the washer.
Use the universal wrench to adjust the level-
ing legs so the washer is level front-to-rear and
side-to-side, and stable corner-to-corner.
Press down on alternate corners and sides and
feel for the slightest movement. Adjust the
appropriate leg(s) so the washer sits solidly on
the floor on ALL four legs. Keep the leveling leg
extension at a minimum for best performance
of the washer.
Connecting inlet water
1. Run some water from the hot and cold faucets
to flush the water lines and remove particles
that might clog the water valve screens and to
determine which faucet is hot and which is cold
supply.
2. Look in the end of each water supply inlet hose
and verify that the rubber washers are in place.
RUBBER WASHERS
MUST BE PRESENT
f
J
J
J
3. Connect the HOT inlet hose to the HOT water
supply and the COLD inlet hose to the COLD
water supply. Tighten by hand until snug.
4. Tighten each supply connection another 2/3
turn with pliers. Do not bend, kink or pinch
water inlet hoses.
5. Turn on the water and check for leaks.