Sennheiser e 604 Specifications

e 604
FEATURES
Rugged reinforced glass fiber body
Low sensitivity to impact and handling
noise
Very high sound pressure handling
capability (in excess of 160 dB)
Low distortion microphone
Hum compensating coil
Easy to position due to compact design
Integral stand mount
ARCHITECT'S

SPECIFICATIONS

The instrument microphone shall be a dyna-
mic cardioid designed for use with drums and
percussion as well as brass and woodwind
instruments.
It shall have a compact design and a rugged
reinforced glass fiber body and shall feature
an integral stand mount. The microphone
shall be fitted with a hum compensating
coil. The frequency response shall be 40 Hz –
18,000 Hz and the sensitivity (free field, no
load) shall be 1.8 mV/Pa at 1 kHz. Nominal
impedance shall be 350 O, with a min.
terminating impedance of 1 kO.
The microphone shall provide a 3-pin XLR
connector. Dimensions shall be 33 x 59 mm
(1.3" x 2.32"). Weight without cable shall
be 60 grams (2.12 oz). The microphone
shall be the Sennheiser e 604.
Cardioid instrument microphone for drums,
percussion, brass and woodwinds
The frequency response and cardioid pick-up pattern are optimized for drum sets
and other percussion instrument miking, while also producing exceptional results
on all forms of brass and woodwind. An integral stand mount screws directly
onto mic stands and included clip attaches mic to rims of drums. Very high sound
pressure level handling, in excess of
160 dB, is combined with a balanced,
clear, low distortion signal. Light-
weight voice coil provides extended
high frequency and rapid transient
response. A tough reinforced glass
fiber body takes the knocks and
shocks.

TECHNICAL DATA

Transducer principle ...............................................dynamic
Pick-up pattern ........................................................cardioid
Frequency response ...............................................40 – 18,000 Hz
Sensitivity (free field, no load at 1 kHz) ...........1.8 mV/Pa
Nominal impedance ................................................350 Ohm
Min. terminating impedance ................................1000 Ohm
Connector ..................................................................XLR-3
Dimensions ...............................................................Ø 33 x 59 mm
Weight w/o cable ....................................................60 g
DELIVERy INCLuDES
1 e 604
1 Drum clip
1 Pouch
Instructions for use