Using The Setup Wizard - NETGEAR DGN3500 User Manual

Checking for Firmware Updates screen. After initial configuration, this screen displays
•
unless you previously cleared the Check for Updated Firmware Upon Log-in check
box.
Figure 2.
If the wireless modem router is not configured (is in its factory
Note:
default state) when you log in, the Setup Wizard displays. See
the Setup Wizard
If the wireless modem router discovers a newer version of the firmware, you are asked if
you want to upgrade to the new firmware (see
details). If no new firmware is available, the following message displays.
Figure 3.
Router Status screen. The Router Status screen displays if the wireless modem router
•
has not been configured yet or has been reset to its factory default settings. See
N300 Wireless Modem Router Status Information
You can use the Setup Wizard to automatically detect your Internet connection as
described in

Using the Setup Wizard

manually configure your Internet connection as described in
Configuring Your ISP Settings
Using the Setup Wizard
You can manually configure your Internet connection using the Basic Settings screen, or you
can allow the Setup Wizard to detect your Internet connection. The Setup Wizard searches
N300 Wireless Gigabit ADSL2+ Modem Router DGN3500
on page 9.
on page 9, or you can bypass the Setup Wizard and
on page 10.
Connecting Your Router to the Internet
Upgrading the Firmware
on page 50.
Viewing or Manually
9
Using
on page 48 for
Viewing