Operation - Lindy 38122 User Manual

User Manual
5. The following text will appear on screen, press OK.
Adding TX123456 (where 123456 is the unique identifier for your Transmitter)
Press OK to continue to Exit to cancel
6. Adding TX123456 will appear on screen along with a status bar showing the progress of the
pairing.
7. Once the pairing has completed Connected to TX123456 will be shown on your display.
To add additional Transmitter units repeat Steps 1-7 for each transmitter. These steps can also
be repeated using multiple receiver units to allow the transmitter to be paired with multiple
receivers, however only a single transmitter may be used with a single receiver, it is not possible
to concurrently use multiple receivers with a single transmitter.
Once you have finished adding transmitter/receiver units you may begin to use the extender.
If you have only one Transmitter and Receiver they will automatically connect when both units
are powered on. If you have multiple Transmitters your Receiver will attempt to connect to the
last Transmitter that it was connected to. If you want to connect to a different Transmitter, press
the Source button on the remote control, highlight the desired transmitter and then press OK.

Operation

Once all equipment is turned on the Extender will initiate a Wireless link, successful connection
of the link will be shown by the blue Wireless Link LED on both the Transmitter and Receiver
units. This may take a short while depending on the distance between the units and other
environmental factors.
When the initial Wireless Link has been established the Extender will then establish a Video
Link between the Transmitter and Receiver units, once this has been completed a second blue
Link LED will be lit on both units. Whilst the Extender is creating the video link it is normal for
your HDMI display to flicker on and off. With both the Wireless and Video Link LEDs illuminated
the Extender is ready to transmit video.
IR Extender Function
You may control your HDMI source device remotely using the IR Extender function using the
following instructions.
1. Ensure that the IR Eye on the Receiver unit is positioned to receive IR commands
2. Connect the supplied IR Extender Cable to the IR Input on the Transmitter unit
3. Position the IR Flasher near the IR Port of your source device
You can now control your source device from the display side of your installation, using the
source remote control.
5
English