Force 10 65335 Owner's Manual page 5

65335 / 65336 Installation
Cutout Dimensions:
Width: 20.375" (518 mm)
Depth: 21" (534 mm)
Height: 21.75" (553 mm)
The opening between the cabinets should be 20.375" (518mm) wide, a minimum of
21" (534mm) deep and 21.75" (553mm) high for proper gimbal.
Mount a gimbal bracket on each side of the opening, positioning the bottom edge of
the bracket 3.75" (95mm) below the countertop, and the front side of the bracket 6.7"
(170mm) back from the front edge of the cabinets. This will position the stove so that
the top of the stove side is flush with the countertop and the stove cabinet will be
flush with the front surface of the adjacent cabinets.
Be sure to maintain a minimum 1" (25mm) open space behind the range, and at least
2" (51mm) of space below to allow the range to gimbal correctly.
Level each bracket and fasten with four #12 wood screws at least 1/2" in length.
Drill a 3/8" (10mm) hole on each side of the opening for the gimbal pin. Locate the
hole 0.47" (12mm) in from the face of the cabinet and 3.55" (90mm) below the
countertop. Fasten the gimbal lock plate over the hole using two # 8 wood screws at
least 3/8" in length.
Carefully lift the stove into position so that the gimbal pins snap into the brackets.
Gently pry the safety tabs of the bracket inward, toward the stove so that they
protrude over the gimbal pins.
Make sure the stove swings freely at least 15 degrees. Check to ensure the gimbal
lock pins slide into the hole you drilled.
75331 / 75332 Installation
Cutout Dimensions:
Width: 20.5" (521 mm)
Depth: 19" (483 mm)
Height: 21.5." (546 mm)
The opening between the cabinets should be 20.5" (521mm) wide, a minimum of 19"
(483mm) deep and 21.5" (546mm) high.
Secure the stove into position by screwing the stove sides to the walls of the cut out.
The mounting holes can be accessed through (2) holes on both side of the stove
located just above the glass top. Use #6, 1" stainless steel wood screws.
Page 3 of 8
ENG-0091.3