Power Led; Part Setting The System - GARDINER TECHNOLOGY 2897PDF Quick Start User Manual

Power LED

The Power LED gives an indication of that the mains supply to the unit is good. It
should be illuminated at all times except when User Programming mode is being
used. Please refer to User Programming Mode section for more details.
Setting the System
When you set the system fully all zones are active after the setting delay has
expired.
After exiting and securing the premises always wait until the exit sounders have
stopped before leaving.
To Abort Setting During Exit Time

Part Setting the System

Your installation engineer may have programmed up to two part sets for your
system, these part sets are defined below.
Part 1
Part 2
A third part set is also available as defined below.
Part 3
Your installation engineer will provide you with information about system zones that
are programmed as part set zones (if any).
A group of system zones that will be removed (turned off)
when Part 1 set is used. Some or all of these zones may also
be contained within Part 2.
A group of system zones that will be removed (turned off)
when Part 2 set is used. Some or all of these zones may also
be contained within Part 1.
All system zones that are programmed as Part 1 and Part 2
will be removed (turned off) when Part 3 set is used.
Exit Wait