Download
Share
Print this page
  1. Manuals
  2. Brands
  3. GARDINER TECHNOLOGY Manuals
  4. Security System
  5. Gardtec 370 581
  6. User instructions

GARDINER TECHNOLOGY Gardtec 370 581 User Instructions

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
G G
a a
r r
d d
t t
e e
c c
G G
a a
r r
d d
t t
e e
c c
3 3
7 7
0 0
5 5
8 8
1 1
/ /
5 5
8 8
2 2
3 3
7 7
0 0
5 5
8 8
1 1
/ /
5 5
8 8
2 2
User Instructions

Advertisement

loading

Related Manuals for GARDINER TECHNOLOGY Gardtec 370 581

Summary of Contents for GARDINER TECHNOLOGY Gardtec 370 581

  • Page 1 User Instructions...
  • Page 2 USER MANUAL Contents Introduction Keypads User Levels and Options Master Code Flow Chart Setting and Unsetting the System Removing Zones and Setting the System Testing the System Viewing the Log Setting the Chime On/Off Changing Codes Resetting after an Alarm Display Messages System Status...
  • Page 3 USER MANUAL RESET If programmed by the engineer allows the system to be reset after an alarm. REMOVE Set the system with one or more zones (selected by the Master user) removed. TEST Allows the system to be tested (zones and bells/strobe) Allows the Log to be read.

  • Page 4: Setting And Unsetting The System

    USER MANUAL Setting and Unsetting the System With the system Unset (display showing 'Un') enter a Master code and screen will flash If YES was Pressed With system Unset enter System fully set code other than Master (eg User code) & system will start to Set then:- Whilst the system is If 1 was Pressed...

  • Page 5: Testing The System

    USER MANUAL Testing the System With the system Unset Enter Master Code and press NO until screen flashes:- Press YES Whilst in this mode any zones activated will generate a tone and be displayed. Pressing 9 whilst in this mode will sound the Bells and flash the Strobe.
  • Page 6 USER MANUAL Setting Chime On/Off With system Unset Enter Master Code and press NO until screen flashes. May show On Press YES Press NO Note: Zones on Chime must be programmed by the engi- May show Off neer before this function will operate.

  • Page 7: Resetting After An Alarm

    USER MANUAL Resetting After an Alarm One of four reset modes may have been programmed by your engineer. Any Code The system will reset the next time Any Code is used to set the system. Master Code The system will only reset if the Master Code or Engineer code is used to set the sys- tem.
  • Page 8 USER MANUAL Display Messages (Log) Apart from the System and Status displays the following messages may also appear whilst viewing the Log. System Full Set System Part 1 Set System Part 2 Set System Part 3 Set ' o1 ' Unset User 1 ' o2 ' Unset User 2...