Network; Wan; Wired Access - Netis WF2414 User Manual

4.4. Network

4.4.1. WAN

This item provides two access types for you to configure the WAN parameters. They are
wired access and wireless access.
4.4.1.1.

Wired Access

Ø
Internet Access Type: Ask for your ISP to get the correct access type.
Ø
IP: The IP address you obtained after connect to the Internet, if you haven't connected to
the Internet yet, this field is 0.0.0.0.
Ø
Subnet Mask: The Subnet mask you obtained after connect to the Internet, if you haven't
connected to Internet yet, this field is 0.0.0.0.
Ø
Gateway: The IP address of Default gateway you obtained after connect to the Internet, if
you haven't connected to Internet yet, this field is 0.0.0.0.
Ø
MTU: The MTU (Maximum Transmission Unit) setting specifies the largest packet size
permitted for network transmission. Most DSL users should use the value 1492.You can
set MTU manually, and you should leave this value in the 1200 to 1500 range. If the value
150Mbps/300Mbps Wireless-N AP / Repeater / Router client User Manual
Figure 4-17
Figure 4-18
35