Part 3 - Canister Cleaner & Attachments; Converting To A Canister Cleaner - Kirby Sentria II Owner's Manual

Canister Cleaner & Attachments
PART THREE
Your Kirby ® Sentria ® system comes with a wide variety of
attachments for added versatility. In this section, we will
discuss the following:
Removing the Power Nozzle to Convert to a
Canister Cleaner
Using the Attachments
Using the Suction Control Grip
Using as a Blower Unit
Using the Portable Sprayer and the
Portable Shampooer

CONVERTING TO A CANISTER CLEANER/

INSTALLING THE ATTACHMENT HOSE
When using different cleaning attachments, the Attachment Hose is
connected to the front of the cleaner in place of the Power Nozzle .
NOTE: When connecting the Attachment Hose, you may choose
between the Upright Handle ⑰or the Portable Handle ⑰. To install
the Portable Handle, see page 14.
1
To install the Attachment Hose, you must first convert to a Canister
by removing the Power Nozzle. To do so, press the Toe-Touch
Control Bottom Pedal ⑨ all the way down until nozzle is fully
raised. Disengage Tech Drive ® power assist by stepping on the gray
"N" side (marked "N" for Neutral) of the Tech Drive N/D Pedal ⑪.
Turn the Sentria ® system OFF by pressing the Power Switch ⑬
and then unplugging. ➤
2
Raise the Headlight Hood  and flip out the handle on the Belt
Lifter ⑳. Use it to turn the Belt Lifter all the way to the left
(counter-clockwise) until the red arrows line up.
3
Unlock the Power Nozzle by turning the Accessory Lock 
all the way to the left (counter-clockwise). The Power Nozzle
should tip forward when it is released. Lift the nozzle away
from the Sentria system. ➤
16