Adjusting Volume; Radio; Listening To Radio; Presetting Stations Manually - Alpine CDE-182R Owner's Manual

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.
Controllable with Remote Control (CDE-182R/CDE-181 Series/
CDE-180 Series only)
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
Remote control sensor
Connectable to Remote Control Interface Box
(CDE-182R/CDE-181 Series/CDE-180 Series only)
With an optional Alpine Steering Wheel Remote Control Interface
Box (not included), this unit is controllable from the vehicles
steering wheel controls. For details, contact your Alpine dealer.

Radio

SOURCE/
Rotary encoder
/ENTER
BAND
TUNE/A.ME

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  F3 (FM3)  MW  LW  F1 (FM1)
3
Press TUNEA.ME to select the tuning mode.
SEEK DX (Distance mode)  SEEK LOCAL (Local mode) 
MANUAL (Manual mode)  SEEK DX
Distance mode (Initial setting):
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning). The "
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
In Manual mode, holding down  or  will change the
frequency continuously.

Presetting Stations Manually

1
Select the radio band and tune in a desired radio station
you wish to store in the preset memory.
2
Press and hold for at least 2 seconds, any one of the preset
buttons (1 through 6) into which you wish to store the
station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 30 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
Preset buttons
(1 through 6)
" indicator lights up.
9
-EN