Advertisement
WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR BULL NOSE RISERS ARE NOT INCLUDED
AND HAVE TO BE PURCHASED SEPARATELY.
Connect water supplies to FAUCET (1) with 1/2" IPS
FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
Use adjustable wrench to tighten connections.
Do not over tighten. Be careful not to kink copper supply
when bending. Use tubing cutter to cut to proper length.
FINISH DRAIN INSTALLATION
Position BIDET fixture and secure to floor.
Insert lift rod into lift rod guide.
Position EXTENSION ROD (1) onto POP-UP ROD (2) and tighten
THUMBSCREW (3).
Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends
together while sliding.
Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1)
and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.)
Adjust STOPPER height by repositioning EXTENSION ROD (1) and
tightening THUMBSCREW (3).
Using metal TAILPIECE (5), make connection to the TRAP (6).
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove HANDLE and ADAPTER if present.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90 and replace.
Replace SPRING CLIP (1).
Replace HANDLE ASSEMBLY.
Spray may accumulate dirt
causing distorted and reduced
water flow. Remove spray and
rinse clean.
Replace Spray and operate
handles several times from
OFF to ON position. Do not
force, handles turn only 90˚.
EverClean™ Finish Care Instructions
American Standard's EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
90
2
1
1
2
3
2
3
1
5
6
TEST INSTALLED FAUCET
With handles in OFF position, turn on
water supplies and check all connections
for leaks.
Operate both handles to flush water lines
thoroughly. Turn diverter to rim wash and
bidet spray.
COUPLING NUT
FERRULE
1
7
4
Advertisement
