Advertisement
DRAIN INSTALLATION
Assemble O-RING (1), WASHER (2), PIVOT ROD (3)
and NUT (4) to DRAIN BODY (5). Concave side
of cup WASHER (2) is toward ball.
Thread LOCKNUT (6), WASHER (7) and
GASKET (8) onto DRAIN BODY (5).
Apply a bead of PUTTY to underside
of FLANGE (9).
Feed DRAIN BODY (5) up through BIDET
and thread FLANGE (9) fully onto
BODY (5).
Tighten LOCKNUT (6) firmly, keeping
the PIVOT ROD (3) pointed towards
the back of the BIDET.
Push DRAIN ESCUTCHEON (10)
onto TAILPIECE (11).
LIFT ROD GUIDE INSTALLATION
Unscrew LIFT ROD NUT (1) from LIFT ROD GUIDE (2).
Make sure SEAL (3) is seated into ESCUTCHEON of
LIFT ROD GUIDE (2).
Drop LIFT ROD GUIDE (2) into rear hole of bidet and from
below secure with ROD GUIDE NUT (1).
TEE AND HOSE CONNECTION
Insert SEAL (1) into ADAPTER (2) and tighten ADAPTER (2)
to bottom of TRANSFER VALVE (3).
Install SEAL (4) into coupling nut of TEE (5) and tighten
connection to ADAPTER (2)
Connect HOSE COUPLING NUTS (6) to Hot and Cold
valve bodies and securely tighten.
HANDLE INSTALLATION
See separate instruction sheet supplied with handle kit
for installation of handles.
STOPPER
9
PUTTY
BIDET
8
CLIP
4
7
2
6
1
5
11
10
SPRAY INSTALLATION
Assemble SPRAY BODY (1) to BIDET.
Using putty, seal underside of SPRAY
BODY FLANGE (2) and secure with
NUT (3).
Screw SPRAY HOSE (4) with SEAL
WASHER (5) to SPRAY BODY (1).
Connect other end of HOSE (4) with
SEAL WASHER (6) to side outlet
NIPPLE (7) of the TRANSFER VALVE (8).
Screw SPRAY CAP (9) onto SPRAY BODY (1).
8
7
6
3
6
9
2
PUTTY
1
7
3
5
4
2
3
1
3
1
2
6
4
5
Advertisement
