BONAIRE Owner's Manual page 30

Multi-Appliance Comfort Control
Ducted Reverse Cycle
YOUR AIR CONDITIONER WILL NOT OPERATE
Question
Has the unit been run
1.
since installation?
Is the unit installed in a
2.
new home?
Has the installer run the
3.
unit?
Is the controller set to
4.
operate in the correct
mode and is the SET
TEMP higher or lower
than the room
temperature?
Is the controller in
5.
program mode?
Is RESET showing on
6.
the controller display?
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO
!
Y/N Solution
Yes Refer to question 4
No Check that the main switch is turned ON, Check and replace the
batteries in the controller (RF Handset Only).
Yes Refer to question 3
No Refer to question 4
Yes Refer to question 4
No Check that the unit is turned ON at the main switch. Contact your
dealer to commission the unit.
Yes Press the reset buttons or turn the unit off then on to reset unit. If
the unit still does not start call for service. (refer to solution 6 for
reset instructions) NOTE: Remember your system is fitted with a
start-up and changeover delay timer to prevent compressor
damage.
No Follow the instructions in 'USING YOUR COMFORT
CONTROLLER – GENERAL OPERATION' located at the
beginning of this manual and set the controller correctly.
Yes The air conditioner may be programmed to be OFF. To operate
the air conditioner manually press the Manual / Auto button until
the MANUAL is displayed. Adjust the room SET TEMP as
desired.
No Refer to question 4
Yes Reset the unit. This can be done by:
1. Following the RESET procedure on 'Page 28', or,
2. Turn the appliance Off, then ON at the unit power isolator
No Unit should operate normally. If not contact your authorised
Climate Technologies service provider.
THE WARRANTY SECTION OF THIS BOOK
Page 30