Mp3 Player - Philips HTB5151K/93 User Manual

Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, or if fewer than five
stations are found, you are prompted to install the
radio stations again.
1
Connect the FM antenna to the TUNER at
the back of your home theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
repeatedly until RADIO
Press
appears on the display panel.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button Action
/ Select a preset radio station.
or
Alphanumeric
buttons
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
(Play).
Manual:
1) Press
/
Press
the radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. When you
switch the tuning grid, all preset radio stations
are erased.
1
repeatedly until RADIO
Press
appears on the display panel.
2
Press .
3
Press and hold
50 kHz or 100 kHz.

MP3 player

Connect a MP3 player to play audio files.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the MUSIC
iLINK connector on your home theater.
• If you use 6.5mm stereo audio cable,
connect the MP3 player to your
home theater using a 3.5mm - 6.5mm
converter jack.
2
Press repeatedly until MUSIC I-LINK
appears on the display panel.
3
Press the buttons on the MP3 player to
select and play audio files.
. 2) Press
to select your preset. 3)
again to store
(Play) to toggle between
EN
23