Related Manuals for Electrolux CEI30EF3JSA
Summary of Contents for Electrolux CEI30EF3JSA
- Page 1 Installation Instructions 7() _ F_ec_Sta_,_di_,_!:__i/_:_ct_ic Ra__:_: _ Instructions d'installation Electrolux...
- Page 2 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Clearances and Dimensions Provide adequate clearances between the range and adjacent combustible surfaces. Location--Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor.
-
Page 3: Important Safety Instructions
iMPORTANT SAFETY iNSTRUCTiONS For electrical supply connection: If the information in this manual is not followed • 1/4" & 3/8" Socket driver or Nutdriver exactly, a fi re or electrical shock may result causing property Additional Materials You May Need damage, personal injury or death. - Page 4 Drill Pilot Holes and Fasten Bracket - Drill a 1/8" pilot 2. Electrical Connection Requirements hole where screws are to be located. If bracket is to be Plug the range power cable (4 conductors) intoa 4 conductor mounted to the wall, drill pilot hole at an approximate 20 ° range outlet.
-
Page 5: Model And Serial Number Location
Model and Serial Number Location The serial plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. - Page 6 L'INSTALLATION ET L'ENTRETIEN DOIVENT f:TRE EFFECTUE_S PAR UN INSTALLATEUR QUALIFli_ IMPORTANT: h. CONSERVER POUR CONSULTATION PAR L'INSPECTEUR EN I'==LECTRICITi"=. USEZ ET CONSERVEZ CES INSTRUCTIONS POUR CONSULTATION FUTURE. Dimensions et espaces libres Laissez des espaces libres ad_quats entre la cuisiniere et les surfaces combustibles adjacentes.
- Page 7 DiRECTiVES IMPORTANTES DE SECURITE Un feu ou une electrocution peut survenir et Pour le raccordement de I'alimentation electrique 8tre la cause de dommages b. la propriet6, de blessures ou Des tourne-ecrous ou douilles de 1/4" et 3/8" entraTner la mort si les instructions de ce manuel ne sont Materiel supplementaire dont...
- Page 8 Percez les trous d'aiignement et fixez le support - Percez un trou de 3 mm (1/8") aux endroits oQ les vis seront Iocalis6es. Percez un trou d'alignement a. un angle descendant d'approximativement 20 -0 si le support doit 6tre install6 sur lemur. Percez un trou d'alignement de 5 mm (3/16") par 44 mm (1-3/4") de...
- Page 9 Emplacement du no. de modele/ no. de s6rie La plaque signal6tique est Iocalisee sur la surface & droite du devant du cadre du foumeau, b. la pattie inferieure du panneau derriere le devant du tiroir rechaud ou de rangement. Assurez vous de toujours fournir le no. de modele et de serie ainsi que le no.
- Page 10 Electrolux...