Advertisement
Available languages
Available languages
Important
Notes
to the Installer
1.
Read all instructions contained in these installation
instructions before installing range.
2.
Remove all packing material from the oven
compartments before connecting the electrical supply
to the range (see "Preparation ", page 6).
3.
Install the 4 shipping bolts from range packaging as
range leveling legs (see "Levelingthe Range", page 7)
4.
Two anti-tip brackets MUST be removed from lower
back of range and MUST be installed (see "Anti-Tip
Bracket Installation ", page 8).
5.
Observe all governing codes and ordinances.
6.
Be sure to leave these instructions with the consumer.
Important
Note
to the Consumer
Keep these instructions with your owner's guide for future
reference.
IMPORTANT
SAFETY
INSTRUCTIONS
• Be sure your range is installed
and grounded
properly by a qualified installer
or service
technician.
• This range must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70--latest
edition.
• The installation of appliances designed for
manufactured (mobile) home installation must conform
with Manufactured
Home Construction and Safety
Standard, title 24CFR, part 3280 [Formerly the Federal
Standard for Mobile Home Construction and Safety,
title 24, HUD (part 280)] or when such standard is not
applicable, the Standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites,
Communities and Setups), ANSI Z225.1/NFPA 501A-
latest edition, or with local codes.
®
®
All ranges
can tip.
Injuryto
persons could
result.
Install anti-tip
device
packed with
range.
To reduce the risk of
tipping of the range, the
range must be secured
by properly installed anti-
tip bracket (s) provided
with the range. To
check if the bracket (s) is
installed properly,
remove the lower panel
or storage drawer and
verify that the anti-tip
bracket (s) is engaged.
• Make sure the wall coverings around the range
can withstand the heat generated by the range.
• Before installing the range in an area covered
with linoleum or any other synthetic floor
covering, make sure the floor covering can
withstand
heat at least 90°F/32°C above room
temperature
without shrinking, warping or
discoloring. Do not install the range over carpeting
unless you place an insulating pad or sheet of 1/4" (6.4
mm) thick plywood between the range and carpeting.
• Do not obstruct the flow of combustion air at the
oven vent nor around the base or beneath the
lower front panel ofthe
range. Avoid touching the
vent openings or nearby surfaces as they may become
hot while the oven is in operation.
This range requires
fresh air for proper burner combustion.
[l,W:_:l,_ll_[_l
Never leave children alone or
unattended
in the area where an appliance is in use.
As children grow, teach them the proper, safe use of all
appliances. Never leave the oven door open when the
range is unattended.
[I_W/'-_;I_II_[_I
Stepping,
leaning
or sitting
on the
door(s)
or drawer
of this range can result in serious
injuries
and can also cause damage
to the range.
• Do not store items of interest to children in the
cabinets above the range. Children could be seriously
burned climbing on the range to reach items.
• To eliminate the need to reach over the surface
units, cabinet storage space above the units
should be avoided.
• Do not use the oven as a storage space. This
creates a potentially hazardous situation.
• Never use your range for warming or heating the
room. Prolonged use of the range without adequate
ventilation can be dangerous.
• Do not store or use gasoline or other flammable
vapors and liquids near this or any other
appliance. Explosions or fires could result.
• Reset all controls to the "off"
position after using
a programmable
timing operation.
FOR MODELS WITH SELF-CLEAN FEATURE:
• Remove broiler pan, food and other utensils
before self-cleaning the oven. Wipe up excess
spillage. Follow the predeaning instructions in the
Owner's Guide.
2
Advertisement
