Advertisement
.
.
.
Cable
Tie
.
INSTALLATION
Run some water from the
hot and cold faucets to flush
the water lines and remove
particles that might clog up
the water valve screens.
Connect the inlet hose ends
to the HOT and COLD water
faucets
tightly
by hand,
then tighten another 2/3 turn
with pliers. Turn the water on
and check for leaks.
NOTE: Use only new hoses provided with this unit.
Carefully move the washer to its final location.
Rollers on the rear of the washer allow for easy
movement in undercounter
installations.
Gently
lift up on the front of the washer and slide back.
NOTE: Lifting up more than 1/8" will engage the
rear legs. Do not use the dispenser drawer
or door to lift washer.
With the washer in its final position, place a level
on top of the washer
(if an undercounter
installation, no rocking of the washer should exist).
Adjust the front leveling legs up or down to ensure
the washer is resting solid. Turn the lock nuts on
each leg up towards the base of the washer and
snug with a wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The farther
out the legs are extended the more the
washer will vibrate.
The washer is designed to operate resting on its
rear rollers, tfthe floor is not level or is damaged,
the rear leveling legs may have to be extended.
For undercounter installations, rear leg adjustment
is accessible through the front service panel.
Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place in a
laundry tub or standpipe and secure with the cable
tie provided in the enclosure package.
NOTE: If the drain hose is placed in a standpipe
without forming a U shape, a siphoning
action could occur. There must be an air
gap around the drain hose. A snug hose
fit can also cause a siphoning action.
@
Cable Tie
Cable
Tie
Cable
Tie
6.
Plug the power cord into a grounded outlet.
NOTE:
Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
7.
Turn on the power at a circuit breaker/fuse box.
8.
Read the Operating
Instructions
and Owner's
Guide provided with the washer. They contain
valuable and helpful information that will save you
time and money.
9.
Run the washer through a complete cycle. Check
for water leaks and proper operation.
10. If your washer does not operate, please review
the "Avoid Service
Checklist"
in your Owner's
Guide before calling for service.
11. Place these instructions
in a location near the
washer for future reference.
NOTE: A wiring diagram is located inside the washer
on the service panel.
REPLACEMENT
PARTS
If replacements
parts are needed for your washer,
contact the source where you purchased your washer
or call 1-800-944-9044
for the Frigidaire Company
Authorized Parts Distributor nearest you.
Destroy the carton and plastic bags
after the washer is unpacked. Children might use them
for play. Cartons covered with rugs, bedspreads,
or
plastic sheets can become airtight chambers causing
suffocation. Place all materials in a garbage container
or make materials inaccessible to children.
_The
instructions in this manual and all
other literature included with this washer are not meant
to cover every possible condition and situation that
may occur. Good safe practice and caution MUST be
applied when installing, operating and maintaining any
appliance.
Maximum benefits and enjoyment
are achieved
when all the Safety and Operating instructions are
understood and practiced as a routine with your
laundering tasks.
Advertisement
