Advertisement
STOP
RZB
°
DRAZR
HOSE
TABS
•'\,\\
SPRZNG
CLAMP
\
PROVIDED
;
ON
HOSE
f
PUSH ROSE ONTO
COUPLER TO STOP RIB
.
S
Using pliers, squeeze the ears of the spring clamp
and position tile clamp so the clamp ears_
with
and contact the tabs on the drain hose. This as-
sures proper location of the clamp to prevent leaks.
ALZGN
SPRING
CLAMP
EARS WITH
TABS
ON ROSE
TABS
/
7-ORIENT
HOSE TO
/
RIGHT_
LEFT,
UP
OR DOWN AS NEEDED
BEFORE PLACING
CLAMP IN POSITION
\
J
/
r
J
j.J
\
ALWAYS ALIGN
CLAMP EARS
WZTH TABS ON HOSE
.
.
.
INSTALLATION
Run some water from the hot
and cold faucets to flush the
water
lines
and remove
particles that might clog up
the water valve screens.
Remove the inlet hoses and
rubber washers from tile
plastic bag located in the
drum
of the washer and
install the rubber washers in
each end of the inlet hoses.
Carefully connect the inlet hose (90° elbow end)
marked "HOT" to the outside "H" outlet of the water
valve. Tighten by hand, then tighten another 2/3 turn
with pliers. Carefully connect the other inlet hose
(90 ° elbow end) to the inside "C" outlet of the water
valve. Tighten by hand, then tighten another 2/3 turn
with pliers. Do not crossthread
or over-tighten
these connections.
4.
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
2/3 turn with pliers. Turn the water on and check
for leaks.
NOTE;
Use only new hoses.
5.
Carefully move the washer to its final location.
NOTE:
Do not use the dispenser drawer or door
to lift washer.
6.
With the washer in its final position, place a level
on top of tile washer. No rocking of the washer
should exist. Adjust the front leveling legs up or
down to ensure the washer is resting solid. Rear
leg adjustment
is accessible through
the front
service panel.
NOTE; Keep the leg extension at a minimum to
prevent excessivevibration. The farther out
the legs are extended the more the washer
will vibrate.
7.
Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided
in the enclosure
package)
to the
standpipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
Advertisement
