Advertisement
Available languages
Available languages
Cooktop Installation
1. Visually i nspect t hecooktop for damage. Alsomake
sureallcooktop screws a retight (seeFigure 8).
Screws
Figure 8
2. Install the retainer brackets (See Figure 9).
6 Nylon
Position brackets
on unit cutout
center line
Figure 10
Checking
Operation
Refer to the Use and Care Guide for operation.
_Do
not touch cooktop glass or elements.
They may be hot enough to burn you.
The retainer
brackets
MUST be installed,
to meet
local codes or, in their absence, with the National
Electrical
Code ANSI/NFPA No. 70--latest
edition,
or
with CSA Standard
C22.1, Canadian
Electrical
Code,
Part I (see Figure 9).
Cooktop
Countertop
spacer
8=18 x 3/8
Re-_iner bracket
Figure
9
Model
and
Serial
Number
Location
The serial plate is located under the cooktop.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before
You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
3. Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Do not remove the nylon spacers on
the edges of the cooktop.
These spacers center the
cooktop
in the space provided.
The cooktop
must
be centered
to prevent excess heat buildup
that may
result in heat damage or fire (see Figure 10).
Advertisement
