Advertisement
Available languages
Available languages
4. Adjusting
Oven Height
(Model with 1 1/2oven cavity only)
Remove and lay aside the lower vent decorative trim
that is taped to the side or to the top of the oven, The
decorative trim will be fastened to the lower front of tile
oven after it has been installed in tile cabinet,
There is a 1 Y2" height adjustment on models with
extension panel (see figure 4). With this adjustment and
a Y2" trim overhang, a unit can be installed in existing
openings 37 Y2" to 39" high.
Oven Door.
Adjustment
_
Holes
Y
Extension Panel
Mounting Screws
Figure 4
To adjust oven height:
1. Lay oven on its back. (see figure 5).
2. Remove the 6 screws that fasten the side extension
panel to the bottom sides of the oven.
3. Move each panel down to the position that increases
tile oven height to fit your opening. Each position
changes oven height approximately
Y2".
4. Line up tile appropriate
holes in tile side extension
panels and sides of the oven. Put the 6 screws back.
5. Proceed with oven installation. Return to upright
position.
Oven Bottom
..... ,,
Panel
Figure 5
5. Cabinet
Installation
A. Model
With
11/2Oven Cavity
Insert appliance into cutout,
Use ttle4mountingscrews
provided to fasten tile front frame of the appliance to
the cabinet (steps I below), Keep the 2 decorative
screws to fix the decorative trim to tile cabinet (step 2
below), The mounting holes in the front frame of
appliance may be used as a template to locate tile
appliance mounting screw holes on the cabinet,
To fasten the appliance
to the cabinet (figure
6):
1. Use 4 mounting screws supplied to secure the
appliance to the cabinetry. 2 holes are located under
the center vent trim on each side, the 2 other holes
are visible when the drawer is opened.
2. Optional:
Install the decorative trim under tile
appliance (as shown on figure 6) using the 2
decorative screws supplied with the appliance.
Center Vent Trim
Mounting Screws
Mounting
Screws
Decorative
Figure 6
Advertisement
