Clearance Requirements; Explosion Hazard - Frigidaire FASE7073NR2 Installation Manual

Hide thumbs Also See for FASE7073NR2:
Table of Contents

Advertisement

Available languages

Available languages

Manufactured
or mobile
home installation
1
Installation MUST conform to current Manufactured
Home Construction & Safety Standard, Title 24
CFR, Part 32-80 (formerly the Federal Standard
for Mobile Home Construction and Safety, Title 24,
HUD Part 280) or Standard CAN/CSAZ240 MH.
2
Dryer MUST be exhausted outside (outdoors, not
beneath the mobile home) using metal ducting
that will not support combustion. Metal ducting
must be 4 inches (10.16 cm) in diameter with no
obstructions. Rigid metal duct is preferred.
3
If dryer is exhausted through the floor and area
beneath the mobile home is enclosed, the exhaust
system MUST terminate outside the enclosure with
the termination
securely fastened to the mobile
home structure.
4
Refer to previous sections in this guide for other
important exhaust venting system requirements.
5
When installing a gas dryer into a mobile home, a
provision must be made for outside make up air.
This provision is to be not less than twice the area
of the dryer exhaust outlet.
6
Installer MUST anchor this (1) dryer or (2) dryer
mounted on pedestal to the floor with approved
Mobile Home Installation Kit - P/N 137067200.
Clearance requirements
EXPLOSION
HAZARD
Do not install the dryer where gasoline or other
flammables are kept or stored. If the dryer is installed
in a garage, it must be a minimum of 18 inches (45.7
cm) above the floor. Failure to do so can result in
death, explosion, fire or burns.
NOT INSTALL YOUR DRYER:
1
In an area exposed to dripping water or outside
weather conditions.
2
In an area where it will come in contact with
curtains, drapes, or anything that will obstruct
the flow of combustion and ventilation air.
3
On carpet. Floor MUST be solid with a maximum
slope of 1 inch (2.54 cm).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents