Dryer Exhaust To Right, Left Or Bottom Cabinet; Tab Location; Adding New Duct; Adding Elbow And Duct For Exhaust To Left/Right Side Of Cabinet - GE DCVH680EJ1WW Installation Instructions Manual

Installation Instructions
19-1DRYER EXHAUST TO RIGHT, LEFT OR
BOTTOM CABINET
WARNING - BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES.
REMOVE
SCREW
AND SAVE.
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
Detach and remove the bottom, right or left side knockout as
desired. Remove the screw inside the drger exhaust duct and
save. Pull the duct out of the drger.
FIXING HOLE
B A
14 11.25"
Cut the duct as shown and keep portion A.
TAB LOCATION
Through the rear opening, locate the tab in the middle of the
appliance base. Lift the tab to about 451A using a flat blade
screwdriver.
ADDING NEW DUCT
FIXING
HOLE
\
PORTION "A"
\
RIGHTOR
LEFT SIDE
EXHAUST
Reconnect the cut portion (A)of the duct to the blower housing.
Make sure that the shortened duct is aligned with the tab in the
base. Use the screw saved previouslg to secure the duct in place
through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST
TO LEFT OR RIGHT SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape around
joint.
Insert duct assemblg, elbow first, through the side opening
and connect the elbow to the drger internal duct.
CAUTION: Be sure not to pull or damage the
electrical wires inside the dryer when
inserting the duct.
o
DUCT
j TAPE
• Applg duct tape as shown on the joint between the drger
internal duct and the elbow.
DUCT
6
CAUTION:
Internal duct joints must be
secured with tape, otherwise
theg mag separate and cause
a safety hazard.