Advertisement
Installation
[] EXHAUST
CONNECTION
_WARNING
- TO REDUCE THE RISK
OF FIRE OR PERSONAL INJURY:
* This dryer must be exhausted to the outdoors.
* Use only metal duct.
* Do not terminate exhaust in a chimney, any gas vent,
under an enclosed floor (crawl space), or into an attic.
The accumulated
lint could create a fire hazard.
* Provide an access for inspection and cleaning of the
exhaust system, especially at turns. Inspect and clean at
least once a year.
* Never
terminate
the exhaust
into
a common
duct
with
a
kitchen
exhaust.
A combination
of lint
and
grease
could
create
a fire hazard.
* Do not obstruct
incoming
or exhausted
air.
WE RECOMMEND THAT YOU INSTALL YOUR DRYER
BEFOREYOUR WASHER. THIS WILL PERMIT DIRECT
ACCESS FOR EASIER EXHAUST CONNECTION
THIS DRYERCOMES READY FOR REAR EXHAUSTING. IF
SPACEIS LIMITED, USE THE INSTRUCTIONS IN SECTION
12 TO EXHAUST DIRECTLYFROM THE LEFT SIDE OR
BOTTOM OF THE CABINET.
STANDARD
REAR EXHAUST
WESTRONGLY RECOMMEND
THEUSE OF
RIGID METAL E XHAUST DUCT. IF USING
FLEXABLE METAL D UCT, CUT ITTOTHE PROPER
LENGTH A NDAVOID BUNCHING O FTHEDUCT
BEHIND T HEDRYER.
Instructions
FOR STRAIGHT
LINE INSTALLATION,
CONNECT
THE
ELBOW H IGHLY
DRYER
EXHAUST
-_ RECOMMENDED.
TOTHE WALL U SING
DUCT TAPE.
ELBOW HIGHLY
RECOMMENDED,
-
RECOMMENDED
CONFIGURATION
TOMINIMIZE
EXHAUST
BLOCKAGE,
NOTE: ELBOWS
WILL PREVENT
DUCT
KINKING
AND COLLAPSING.
[] LEVELING DRYER
LEVEL
FRONT-TO-BACK.
_.
LEVEL
SIDE-T0-SIDE
4 LEVELING LEGS
STAND THE DRYER U PRIGHT NEAR THE
FINAL LOCATION AND ADJUST T HE4LEVELING
LEGS TOMATCH THE HEIGHT O FYOUR WASHER,
ADJUST T HE 2ANTI-TIP LEGS TOCONTACT
THE FLOOR.
2ANTI-TIP LEGS
Advertisement
