Mount The Oveu - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
ADAPTING BLOWER FOR
RECIRCULATION (continued)
_] Place the blower unit back into the o )ening.
l
CAUTION: Do not pull or stretch the blower unit
wiring, Make sure the wires are not pinched,
[] Replace blower plate and replace screws for blower
plate and blower motor remoxed in Step 1.
Blower Plate Screws
__ Blower Plate
I Back of Oven
MOUNT THE OVEN
FOIl EASIER INSTAI,I.¢TION AND PERSONAI,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If yore" cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over tightening
screws.
NOTE: When motmting
the oven, thread power
cord through hole in
bottom of top cabinet.
Kee I) it tight throughout
Steps
1-3. Do not
pinch
cord or lift oven by
mllin , cord
_I,ifl oven, tilt it
flwward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
/
_ Rotate
fFont of oxen
up against cabinet
bottoln.
CabinetFront
CabinetBottomShelf
Equivalent to Depth
f Cabinet Recess
Self-Aligning Screw
Oven Top
21