Aliguiug The Wall Plate - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
ALIGNING THE WALL PLATE
\
H_lole iI Draw a Vertical
^ _ Line on Wall
I<_ from Centerof
i TopCabinet
i
i
HoleC_/' _ _ _ ......................................... 5 ° ° s_ _s _6 _,__
I
,_, ,I,
Area E I
CAUTION: Wear glo_es I
to a_oid cutting fingers on
sharp edges.
[]Draw a vertical line on the wall at the center of the 30"
wide space.
_Use the moui_ting plate as the template for the rear
wall. Place the mom_ting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhm_g. Line up the notch mid center line
on the mounting plate to the center line on the wall.
[] X._l_ile holding the mounting plate with one hand,
draw drcles on the wall at holes A, B, C and D (see
illustration above/actual plate marked with arrows).
Four holes must be used for mounting.
-_------ HoleB
/
/
/
/
Hole D
NOTE: Appearance and
shape of the motmting
plate may wu'v ti'om vom"
model.
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud s()mewhere in area E
and draw a fifth drcle to line up with the stud. It is
important to use at least one wood screw nlounted
firmly in a stud to sui_port the weight of the oven.
Set the mounting plate aside.
[] Dlill holes on the circles. If there is a stud, chill a :"A(;"
hole fin" wood screws. For holes that don't line up with
a stud, dlill a %" hole fin" toggle bolts.
NOTE: DO NOT MOUNT THE PLATE
AT THIS TIME.
10