Mounting Holes - PRICOM Design Dream Player MK2 User Manual

Using your Dream Player MK2
Switch 5
OFF
OFF
Switch 7 – Spare
ON Not used yet
OFF Not used yet
Switch 8 – Auto Start
When power is applied to the Dream Player, playback of Track #1 will
ON
automatically begin playing after about 2 seconds
OFF Playback will NOT automatically start at power-on
All switch modes can be combined in any manner. For example, a useful setup would be
combining Auto Start Mode, Random Mode, and Loop Mode. This would cause the
Dream Player to start playing a random track after power-up, when the track ends, pick
another random track and play. This process would continue until a trigger input is
detected or the PLAY button is pressed.

3.6 Mounting Holes

The Dream Player can be mounted to any non-conducting surface using the supplied
mounting holes. Although there are not any components on the back of the LITE, using
some form of stand-off would be advisable to keep from breaking anything and more
importantly avoid any unwanted short circuits. The mounting holes are electrically
isolated however, and using steel screws is fine, but please do be careful not to over
tighten them.
Switch 6
ON ON
ON OFF
ON
OFF
PRICOM Design
Control Outputs
This mode selection is not used yet
At the END of each track, the respective
Control Output will momentarily go active
or pulse
At the BEGINNING of each track, the
respective Control Output will
momentarily go active or pulse
During PLAY of each track, the respective
Control Output will constantly be held
active
Page 16