Safety Information
BEFORE YOU BEGIN
Read these instructions
completely and carefully.
•Im PO RTANT- save these instructions
for l ocal
inspector's use.
• IM PORTANT-
Observe all governing codes and
ordinances.
• Note to Installer - Be sure to leave these instructions
with the Consumer.
• Note to Consumer - Keep these instructions for
future reference.
• Skill Level - Installation of this vent hood requires basic
mechanical and electrical skills.
• Completion time - i to 3 hours.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
I CAUTION:
Due to the weight and size of this vent hood and to reduce
the risk of personal injury or damage to the product, we
recommend at least three people install
this hood.
. PRUDENCE
:
A cause du poids et de la taille de la hotte et pour
r#duire les risques de blessures ou de dommages de
I'#quipement, nous recommandons que trois personnes
installent cette hotte.
I WARNING:
To reduce the risk of fire or electrical shock, do not use
this range hood with any external solid-state speed
control device. Any such alteration from original factory
wiring could result in damage to the unit and/or create an
electrical safety hazard.
. AVERTISSEMENT
:
Pour r6duire le risque d'incendie ou de choc 61ectrique,
il ne faut pas utiliser cette hotte avec un r#gulateur
de vitesse #lectronique externe. Toute modification de
ce type du branchement d'usine peute endommager
I'appareil ou cr#er un risque de choc #lectrique.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
_ WARNING:
TO REDUCETHE RISKOF FIRE,ELECTRICALSHOCK OR
INJURY TO PERSONS,OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact the
manufacturer.
B. Before servicing or cleaning unit, switch power off at
the service panel and lock service panel to prevent
power from being switched on accidentally. If the
service panel cannot be locked, fasten a tag or
prominent warning label to the panel.
AVERTISSEMENT :
POUR RI_DUIRE LE RISQUED'INCENDIE, DE CHOC
I_LECTRIQUE OU DE BLESSURES, IL FAUTOBSERVERLES
REGLESSUIVANTES:
A. Utiliser cet appareil uniquement de la mani#re
pr#vue par le fabricant. En cas de question, consulter
le fabricant.
B. Avant toute intervention ou nettoyage, couper
I'alimentation #lectrique au disjoncteur et verrouiller
le panneau du disjoncteur pour #viter la mise
sous tension accidentelle. S'il n'est pas possible de
verrouiller
le panneau du disconcteur, attacher un placard ou une
#tiquette tr6s visible au panneau.
• For general ventilating use only. Do not use to exhaust
hazardous or explosive materials or vapors.
• Structural framing, installation work and electrical
wiring must be done by qualified person(s)in
accordance with all applicable codes and standards
including fire-rated construction.
• Sufifcient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA),the American Society for
Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
• Local codes vary. Installation electrical connections and
grounding must comply with applicable codes. In the
absence of local codes, the vent should be installed in
accordance with National Electrical Code ANSI/NFPA
70-1990 or latest edition.
- CAUTION: TO reduce
risk o f f ire and t o
properly exhaust air, be sure to duct air outside-do
not
vent exhaust air into spaces within walls or ceilings or into
attics, crawl spaces or garages.
- PRUDENCE
: II faut prendre soin
d'installer un conduit vers I'ext#rieur pour r#duire le risque
d'incendie et pouvoir #vacuer I'air correctement. II ne faut
pas #vacuer I'air correctement. II ne faut pas 6vacuer I'air
dans I'espace entre les parois d'un mur, un plafond
ou un grenier, un espace sanitaire ou un garage.
Need help?
Do you have a question about the Monogram ZV1050 and is the answer not in the manual?