Powering On - Garrett AT Pro Owner's Manual

12. If needed, adjust the arm cuff by removing the screw on the
bottom. Move the two-piece cuff to the other hole, reinsert the
screw through the headphone cable clip, and tighten.
12.
13. If desired, attach headphones to the 2-pin connector of the
Control Housing. After lining up the connector pins, press the
connector in firmly, yet carefully, until the O-ring is felt to be
fully inserted.
14. Secure the headphone cable under the detector's arm cuff by
pressing the cable into the headphone cable clip.
Note: Headphones are not required but are desired by many
hunters to hear faint targets. Connecting the headphones will
silence the detector's speaker.
Note: The provided headphones are for dry use only; see page
55 for optional waterproof headphones.
14.
10 Garrett Metal Detectors
13.

POWERING ON

ON/OFF Power
and MODE
Pushbutton
Switch the detector on with the power button.
Press and release to switch the unit ON and resume hunting
with the same settings used prior to switching the unit OFF.
To turn off the detector, press and hold this pushbutton for
one (1) second (until the detector produces a second beep).
To restore the factory settings, press and hold the power
button for 5 to 10 seconds (until the detector produces a fast
double beep).
11
AT Pro™