Installation - Bosch DKE9306AUC Installation Instructions Manual

Installation
This hood is intended to be mounted onto
the kitchen wall.
t. Draw a line on the wall from the ceiling
to the lower edge of the hood at the
center of the location where the hood is
going to be mounted. Fig, 4,
2. Using the template, mark positions on
t t. Remove the protective film from the
two flue ducts,
z_ Take care not to damage the
stainless steel surfaces which are
susceptible to scratches etc,
t 2. Push both sections of the flue panelling
together (slots in the upper section
the wall for the screws, Fig, 4,
z_ Ensure that the minimum distance
between the cooking surface and the hood
is maintained - 30". The bottom edge of
the template equates to the lower edge of
the hood.
3. Drill 4 x ¢ 5/1_" h oles for the hood and
2 x ¢ 5/16"holes for the chimney
panelling. Insert plugs into the holes so
must be pointing downwards) and
insert into the opening in the hood.
Fig. 7.
z_ Protect the cover panels from
scratches, for example by laying the
template used for marking the wall over
the top edge of the lower section,
Fig. 7,
that they are flush with the wall, Fig, 4,
Note: Take into account any special
accessories that are going to be fitted.
4. Attach the 2 enclosed spacers to the
fixing bracket for the flue duct panelling,
Fig, 5,
Attach the fixing bracket for the
chimney panelling using two hexagon
head cap screws, Fig, 5.
5. Screw in the two upper hexagon head
cap screws leaving them extended by
approx. %", Fig, 5,
6. Remove the grease filter (refer to
Operating Instructions).
7. Attach the hood to the screws, Fig, 7,
8. Screw in the two lower hexagon head
cap screws, Fig, 6,
z_ Before the 4 screws are tightened
down, align the hood properly.
9. Connect up the air outlet pipe,
t0. Connect the hood to the electricity
supply.
t 3. Slide out the upper section and attach
it to the mounting brackets at the sides
with two screws. Fig. 8,
14. Insert the grease filter (refer to
Operating Instructions),