The.rear.panel - Blackheart BH100H User Manual

The Rear Panel:
SERIES
FOOT
SWITCH
PARALLEL
27
The.rear.panel.has.connections.for.the.AC.
power.cord,.external.speaker.cabinets,.a.
line.out,.an.effects.loop.and.a.footswitch.
WARNING!.Never.turn.on.or.use.the.ampli-
fier.without.a.load.or.speaker.connected.to.
the.amplifier..
21. AC Power Input with Mains Fuse:.
Your.amplifier.is.equipped.with.a.
detachable.power.cable.that.plugs.into.
the.IEC.Mains.socket.on.the.back.of.the.
amplifier..The.AC.power.cord.should.
only.be.plugged.into.a.grounded.power.
outlet.that.meets.all.applicable.electri-
cal.codes.and.is.compatible.with.the.
voltage,.power,.and.frequency.require-
ments.stated.on.the.rear.panel.of.the.
amplifier..Do.not.attempt.to.defeat.the.
safety.ground.connection..The.AC.Mains.
fuse.is.located.in.the.IEC.Mains.socket.
and.is.used.to.protect.the.amplifier.
from.electrical.faults..If.the.fuse.needs.
to.be.replaced,.please.refer.to.the.
correct.fuse.specifications.located.on.
the.back.panel.of.the.amplifier..Always.
unplug.the.power.cord.when.changing.
or.inspecting.the.fuse..Never.bypass.
the.fuse.or.replace.it.with.a.wrong.type.
or.value..
22. RETURN LEVEL: When.in.Series.
mode,.this.control.is.used.as.a.level.
of.returning.wet/dry.signal..In.Series.
mode,.the.wet/dry.signal.is.mixed.thru.
your.effects..When.used.in.Parallel.
mode,.this.control.allows.the.player.to.
increase.the.level.of.the.effects.
SEND LEVEL
0 10
26 25
EFFECT EFFECT
SEND RETURN
24 23
23. EFFECT RETURN:.This.jack.is.desig-
nated.to.be.connected.(using.a.good.
quality.shielded.cable).to.the.output.of.
your.last.external.effect.(if.more.than.
one.effect.is.used)..
24. EFFECT SEND: This.jack.is.designated.
to.be.connected.(using.a.good.quality.
shielded.cable).to.the.input.of.your.first.
external.effect..
25. SEND LEVEL: Use.this.to.control.the.
guitar's.signal.level.that.is.being.sent.
into.your.first.effect..This.allows.you.to.
use.external.rack.effects.and.foot.ped-
als.through.the.effects.loop.
26. SERIES/PARALLEL:.This.switch.allows.
you.to.select.between.Series.or.Parallel.
mode.of.operation.
27. FOOT SWITCH: If.the.foot.switch.is.not.
plugged.into.the.amplifier,.the.FX.loop.
is.ON.and.the.loop's.Send.and.Return.
level.controls.are.active..If.you.are.not.
using.the.footswitch.as.a.level.boost.
and/or.you.are.not.using.the.effect.loop.
for.your.effects,.be.sure.the.Series/
Parallel.switch.is.set.to.Series.and.the.
Send.and.Return.level.controls.are.set.
so.you.do.not.lose.any.signal...
Using the Effects Loop as a Level Boost.
. If.effects.are.not.needed,.the.Effects.
Loop.may.be.utilized.as.a.Level.Boost.for.
your.awesome.lead..Keep.in.mind.that.the.
Effects.Loop.is,.in.fact,.a.(limited).gain.
stage..Therefore,.the.Effects.Loop.may.be.
engaged.in.order.to.meet.that.extra.needed.
gain.or.level.boost..
RETURN LEVEL
0 10
22 21