Table of Contents
Advertisement
Appendix
A. Trouble Shooting
There may be various reasons for the abnormal operation of the receiver.
Check the receiver according to the procedures shown below.
If the receiver does not work properly after checking it, please contact the dealer.
Don't open the receiver cover. It may cause a dangerous situation.
Symptom
The display on front
panel doesn't light up
No picture or sound
No picture
Remote controller
does not working
B. Specifications
1. Conditional Access Interface (CI Model Only)
PCMCIA
2. Conax Embedded
SMART CARD
Cause
The
power
cord
is
plugged in.
Wrong connection of the
Audio/Video output of the
receiver to TV.
Audio muting.
TV power off.
The receiver can't receive the
signal.
Incorrect values of some tuner
parameters.
Wrong direction of the dish
The batteries of the remote
controller are not inserted or
exhausted
2 Slot(type I or type II)
DVB Common Interface Standard
(Viaccess, Nagra Vision, Conax, Cryptoworks, ASTON)
1 Slot
ISO 7816 Compatibility
Remedy
not
Check that the power cord is plugged in to
the wall outlet.
Connect the Audio/Video output of the
receiver to TV correctly.
Press the MUTE button.
Turn TV on.
Check the antenna cable, replace the cable, or
connect the cable to the receiver tightly.
Set the values of tuner parameters correctly in
installation menu.
Check the signal strength with a spectrum
analyzer and adjust your dish correctly.
Check whether the batteries are inserted
correctly in your remote controller
Check the batteries, an if exhausted replace
the batteries of the remote controller
35
Advertisement
Table of Contents
