Zinwell Freeview ZMX-7500 Manual

Digital satellite receiver

Hide thumbs Also See for Freeview ZMX-7500:

Zinwell Freeview ZMX-7500 Digital Satellite Receiver

How to reset to factory defaults:

This procedure should be followed if you are having difficulty receiving the Freeview transmission.

Note: If you are using the RF output and you are unsure of how to retune your TV, DO NOT CONTINUE

WITH THESE INSTRUCTIONS – seek advice from an Installer. This procedure may change the RF

output channel and you may lose the picture. In this case you will need to know how to retune your TV

to the default RF output of the Zinwell receiver, currently Channel 34 (UHF). If you are using AV or

Component Video, continue...

If you are not familiar with the position of all the buttons on the remote control, refer to page 7 of the

User Manual (or p10 if DSE User Manual), for the location of the buttons to press when carrying out the

following instructions. Unless stated, all the instructions below are carried out using the Zinwell

Freeview remote control supplied with your Zinwell Freeview Receiver.

If any step is missed or carried out incorrectly, the reset to Factory Default will fail.

Point the Remote Control at the Zinwell Freeview receiver and continue pointing it at the receiver until

the procedure is complete.

Press the Exit button.

Press the Menu button.

Press the Cursor Down button twice so that "System Configuration" is highlighted.

Table of Contents

Do you have a question about the Freeview ZMX-7500 and is the answer not in the manual?

Page 1 In this case you will need to know how to retune your TV to the default RF output of the Zinwell receiver, currently Channel 34 (UHF). If you are using AV or Component Video, continue…...
Page 2 Press the Cursor Right button once so that “System Setup” is highlighted Press the Cursor Down button three times so that “Factory Default” is highlighted. Press the OK button. (You will get a message: “Password Please!”) Press the 0 (zero) button four times. (You should get a prompt as shown with a box around the “NO” option.) (If you get a message saying "Password Mismatch", enter the password: 1 2 6 9).
Page 3 Wait a few moments until you see a message on the screen, either “Factory Default” or “Please Disconnect Power and Reconnect”. Pull the small black power plug, out of the back right hand corner of your Zinwell Freeview Receiver. You should now have a blank screen Wait 10 seconds and then reconnect the power plug.
Page 4 TV (normally TV1) when finished. If the two indicators remain at zero then your Zinwell Freeview Receiver has failed to detect a signal from the satellite and you will need to repeat the whole procedure from the beginning. If it fails on the second attempt, then there is a problem with the signal reception from your satellite dish.